---
title: "Ice maker repair"
description: "Liebherr ice maker repair — no ice, slow ice, or a control lamp flashing above the ON/OFF button."
url: "https://liebherrmiami.support/services/ice-maker-repair/"
date_modified: "2026-08-27"
---


# Liebherr ice maker repair

### Two free checks before you call

Liebherr’s own ice-maker troubleshooting has exactly three rows, and two of them are about the water tank: enough water in it, and inserted correctly. The third asks whether the drawer is properly closed. Working through those first is the difference between a visit and a solved problem.

What this involves

The maker’s own free checks first

Water path, valve and filter

The flashing lamp explained rather than replaced

Work through the maker’s own list

Is the ice maker turned on? Is the drawer closed properly? Is there enough water in the tank, and is the tank seated correctly? Liebherr publishes exactly these, and they resolve a real share of these calls.

Check the water path

Supply, valve, line and filter on a plumbed cabinet; tank and pump on one that is filled by hand. A filter nobody has changed is a common and cheap answer.

Check the freezing side

An ice maker in a compartment that is not cold enough will make little or nothing, and that is a cooling diagnosis wearing an ice maker’s clothes.

Then the module

Motor, mold heater and the harness, measured rather than swapped.

Two free checks before you call

Liebherr’s own ice-maker troubleshooting has exactly three rows, and two of them are about the water tank: enough water in it, and inserted correctly. The third asks whether the drawer is properly closed. Working through those first is the difference between a visit and a solved problem.

### The lamp above the on/off button is flashing.

The maker documents that one: it is asking about water. Is there enough in the tank, and is the tank properly inserted? Those two checks are the published answer and they cost nothing.

### It makes ice but very slowly.

Usually water rather than the ice maker — a filter at the end of its life, a valve that is not opening fully, or a supply that has been partly closed since somebody worked under the sink. It can also be a freezer that is a few degrees warm, which is why the compartment temperature gets checked at the same visit.

---

**[Read full article: Ice maker repair](https://liebherrmiami.support/services/ice-maker-repair/)**