---
title: "Liebherr freezer column: The temperature display and the alarm LED flash together"
description: "Liebherr freezer column: The temperature display and the alarm LED flash together: liebherr freezer column — an indicator rather than a code."
url: "https://liebherrmiami.support/error-codes/signal-temperature-alarm-led-flashing/"
date_modified: "2026-08-27"
Appliance type: "Freezers"
---


# Liebherr freezer column: The temperature display and the alarm LED flash together

### This is an indicator, not an error code

It always sounds if the freezer temperature is not low enough. The temperature display and the alarm LED flash at the same time. This can be caused by: warm, fresh food being placed in the freezer, too much warm air from the outside entering when re-arranging or removing frozen food, a fault in the appliance. The temperature display will continue to flash until the cause of the alarm has been rectified. (lint-allow — дословно из руководства марки.)

It is on this page because it is what somebody is actually looking at when they go searching. Most of this maker’s equipment publishes no code at all, and an appliance that flashes at you is still telling you something — it simply is not telling you a number.

This is the one people describe as **liebherr freezer alarm beeping**, and on this make it is documented rather than broken.

### What to do

- Give it two hours if you have just loaded warm food or spent a while rearranging the freezer. The maker names both as causes and both clear themselves.
- Check the door seal with a sheet of paper along all four sides — warm air entering continuously is the reason this alarm keeps having a reason.
- If it is still flashing with the door shut and nothing new inside, the freezer genuinely is not cold enough and that is a visit.

### What the repair is

Conditions like this one end at [Alarm and power-failure diagnosis](https://liebherrmiami.support/services/alarm-and-power-failure-diagnosis/) more often than anywhere else. The figure on that page is a starting point; the exact cost is confirmed after an on-site diagnostic and agreed in writing before anything is opened.

Freezer columns

What the machine is telling you

This is an indicator, not an error code

It always sounds if the freezer temperature is not low enough. The temperature display and the alarm LED flash at the same time. This can be caused by: warm, fresh food being placed in the freezer, too much warm air from the outside entering when re-arranging or removing frozen food, a fault in the appliance. The temperature display will continue to flash until the cause of the alarm has been rectified. (lint-allow — дословно из руководства марки.)

It is on this page because it is what somebody is actually looking at when they go searching. Most of this maker’s equipment publishes no code at all, and an appliance that flashes at you is still telling you something — it simply is not telling you a number.

This is the one people describe as liebherr freezer alarm beeping, and on this make it is documented rather than broken.

What to do

Give it two hours if you have just loaded warm food or spent a while rearranging the freezer. The maker names both as causes and both clear themselves.

Check the door seal with a sheet of paper along all four sides — warm air entering continuously is the reason this alarm keeps having a reason.

If it is still flashing with the door shut and nothing new inside, the freezer genuinely is not cold enough and that is a visit.

What the repair is

Conditions like this one end at Alarm and power-failure diagnosis more often than anywhere else. The figure on that page is a starting point; the exact cost is confirmed after an on-site diagnostic and agreed in writing before anything is opened.

---

**[Read full article: Liebherr freezer column: The temperature display and the alarm LED flash together](https://liebherrmiami.support/error-codes/signal-temperature-alarm-led-flashing/)**